Measure something in cetus3d12/1/2023 ![]() ![]() I’m pleased about every help I can get to isolate and fix my problem. Luckily the new barrel is really easy to unclog.įilament path is clear and has almost no frictionįilament path through extruder is straight, everything is alignedĬould it be that I have electrical issues with my cable or the Mainboard, would this make sense in my case? And when so, how can I reliably measure it? However after a few more tries of raising the temperature and test-printing, this was my best result and in the end my nozzle got too hot, melted the filament right in top of the barrel and clogged. I thought this was a really strange behavier, because the nozzle is hot enought to get the high flow part of the print done but not the low flow sections?!? Cetus3D Cetus User Manual V 0.1 Cetus3D. I started a test print and while the nozzle was laying down some first fat raft lines, I was happy that my printer was back in business again.īut I’ve been pleased too early and right at the moment as the printer started with the thin raft lines, the extruder started skipping again.Īnother temperature rise later the printer finished printing the raft and then started skipping at the first bottom layer. Cetus Studio does not currently use the calibration (not nozzle offset, not anything else) when running g-code, so make sure your Cetus is squared, build plate level, etc. It uses the Fused Filament Fabrication technology to produce thermoplastics parts using filament feedstock. There is no silicone sock on this nozzle, maybe raising the temperature will help. The Standard MKII is a 3D printer produced by Cetus3D, a manufacturer based in China. The new nozzle arrived but at its first feed the extruder started skipping again while pushing out just a little bit of filament. It was my last nozzle so i decided to order the new V2 barrel and give that wear resistant nozzle a try. ![]() I have already had pushed about 3 rolls through its tiny. Printed out 0.05mm layer and 99 infill and Fine setting on Cetus 3D.2. Tries to clean it failed with the same result. Replacement C Clip measured from an original for the Madbull Metal Hopup Unit. At first i thought it was a clogged nozzle. It already has the V1 extruder installed.Ī few weeks ago my extruder started badly skipping steps while printing PLA. I own my Cetus MK2 for round about 3 years now. Cetus3D is a subsidiary of Beijing Tiertime Technology LTD.As a truly essential system, the body of Cetus3D is made of aluminum extrusions,the XYZ axis all using stainless steel liner rail,and the machine is simplified into only six modules.There are 3 nozzle options with the preset profiles, 0.2mm, 0.4mm and 0.6mm,which can meet different requi. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |